From full-time ranching to an occasional trip to the stockyards, the Stocker has always been a constant choice of farmers and ranchers. One of CM"s most diversely utilized trailers, the Stocker can be tailored to fit numerous practical uses and applications.

STOCKER
Steel bumper pull stock trailer

Standard Features

Available Sizes
10' floor length w/2-3500# axles, 15" tires & 5-hole wheels 
12' floor length w/2-3500# axles, 15" tires & 5-hole wheels 
14' floor length w/2-3500# axles, 15" tires & 5-hole wheels 
16' floor length w/2-5200# axles, 15" tires & 6-hole wheels 
17' floor length w/2-5200# axles, 15" tires & 6-hole wheels

Dimensions
6' body height
5' or 6' body width (17' available only in 6' width)
(14' x 6' wide models have w/2-5200# axles, 6-hole 15" tires and wheels)
28" tongue length

Undercarriage
Rubber torsion axles with four wheel independent suspension and greasable hubs for easy lubrication
Electric brakes on all wheels
Radial tires on silver modular wheels with chrome center caps
Spare tire rack only

Coupler & Jacks
2" coupler and safety chains with hooks (standard on 5' widths 10'-14' and 6' widths 10'-12')
2-5/16" coupler and safety chains with hooks (standard on 5' widths 16' and 6' widths 14'-17')
Top-wind jack with caster wheel
Emergency breakaway system: switch, cable and battery box complete with battery and charger

Design Features & Hardware
All steel frame with formed galvanneal side panels
12" radius corner galvanneal roof panels
3' sides with 1" x 3" tubing above
Rubber mounted optical window in front
Two chrome circle vents in front
Treated floor
Greasable exterior hinges
Chrome trim with colored vinyl insert
Pin striping
Tag bracket

Load Area Equipment
1" square tubing center gate (no center gate on 10' and 12' models)
Side access door on curb side (no side access door on 10' models)
Full swing half sliding rear gate
Four inside tie rings; no outside tie rings

Lights
DOT required lighting

Contact us for pricing - 800 932-2461

CM Trailers reserves the right to make any change in paint, design, or construction as necessary for engineering. All visual representation, specification, and dimensions are based on the latest product information available at the time of publication. Some of the equipment shown or described is available at extra cost. At no time will any of the material or information contained in this publication have any justifications for resolving disputes. All axle ratings will be listed as per FMVSS 120, Section 5.1 states, the maximum load rating of the tires and rims fitted to an axle shall not be less than the GAWR specified on the certification label.